Eave Lintels

Eave Lintels from South AtlanticSouth Atlantic Eave Lintels

Per International Building Code
R703.7.2.2 Support by roof construction.

The maximum slope of the roof construction without stops shall be 7:12. Roof construction with slopes greater than 7:12 but not more than 12:12 shall have stops of a minimum 3 inch × 3 inch × ¼ inch (76 mm × 76 mm × 6 mm) steel plate welded to the angle at 24 inches (610 mm) on center along the angle or as approved by the building official.

  • 5 x 3½" x 5/16" angle with 9/16" holes and 3 x 3 x 1/4 angle iron stops welded every 24 inches to give support to exterior masonry veneer on sloped roof construction. The use of the 3 x 3 x 1/4 angle instead of the 1/4 x 3 flat bar tabs allows for the lintel to be used on either the left or right side of the roof line
  • Available in either galvanized or primed after fabrication
  • Custom sizes available upon request

South Atlantic Eave Lintel
This picture is not to scale, see blueprint for actual dimensions

Eave Lintels Technical Specs

South Atlantic Eave Lintels Technical Data Sheet
Eave Lintels Technical Data Sheet (PDF)

What do you want to do next? »

Contact South Atlantic MasonryAdd more to my quote

Contact South Atlantic Masonry